300mm (12inch) Single wall flue Dinak

Adapter to connect dinak single wall flue to a boiler

Adapter to connect dinak single wall flue to a condensing boiler

Straight length pipe, effective length 265mm

Straight length pipe, effective length 430mm

Straight length pipe, effective length 930mm

Adjustable pipe can be cut to length required from 65 to 206mm

Adjustable pipe can be cut to length required from 65 to 373mm

Drain length, effective length 265mm

Temperature length

Test unit

Draught regulator.

Elbow allows for a change in direction of the flue run

Elbow allows for a change in direction of the flue run

Elbow allows for a change in direction of the flue run

Elbow allows for a change in direction of the flue run

Elbow allows for a change in direction of the flue run

Inspection elbow 87 degree

Inspection elbow 90 degree

Tee provides cleaning access at the base of the flue

Draught stabiliser.

Tee 135 degree. For natural draft and dry applications

Tee 135 degree. For condensing and overpressure applications

Tee provides cleaning access at the base of the flue

90 degree reducing tee. Reduce from 300mm down to 100mm.

93 degree reducing tee. Reduce from 300mm down to 200mm - 80mm.

Inspection tee

Soot collector, closes off the flue and provides cleaning access at the base of a tee.

Soot collector with drain, closes off the flue for cleaning access at the base of a tee and provides a drain point for any moisture collected.

Soot collector with drain for use in a horizolntal run.

Standard joint clamp for use in dry, non condensing applications

A rubber seal used on condensing installations. 14 inch twin wall flue and 12 inch single wall flue.

Locking band for use in high pressure condensing applications - comes with seal.

Wall support provides lateral stability for the chimney

Adjustable wall support provides lateral stability for the chimney.
Allows for distance adjustment from 70-120mm from the wall surface

Adjustable wall support provides lateral stability for the chimney.
Allows for distance adjustment from 100-250mm from the wall surface.
Excess bracket length can be removed

Adjustable wall support provides lateral stability for the chimney.
Allows for distance adjustment from 250-430mm from the wall surface.
Excess bracket length can be removed

Adjustable base support.

Adjustable floor support.

This guy wire bracket can be Used to stabilise the flue where wall brackets would not be suitable, requires guy wire pack (separate item)

Storm collar, provides extra protection above the flashing where the flue passes through the roof and protects rubber flashings from extreme weather conditions

Rain cap is the final element of the vertical run and provides protection from the rain

The weathering cap is the final element of the vertical run and provides protection from both wind and rain

Open terminal is the final element of the vertical run helps prevent wind affecting the draught in the chimney

Horizontal terminal